CNA requirements
• The use of loopback hoods is not a requirement for running CNA system-level diagnostics tests.
Interconnect requirements
• Both platform controller modules in a dual controller system must be in Maintenance mode for the
interconnect system-level diagnostic test to run.
You will receive a warning message if you attempt to run the interconnect system-level
diagnostic test with other system-level diagnostic tests.
How to use online command-line help
You can get command-line syntax help from the command line by entering the name of
the command followed by help or the question mark (?).
The fonts or symbols used in syntax help are as follows:
•
keyword
Specifies the name of a command or an option that must be entered as shown.
•
< > (less than, greater than symbols)
Specify that you must replace the variable identified inside the symbols with a value.
•
| (pipe)
Indicates that you must choose one of the elements on either side of the pipe.
•
[ ] (brackets)
Indicate that the element inside the brackets is optional.
•
{ } (braces)
Indicate that the element inside the braces is required.
You can also type the question mark at the command line for a list of all the commands that are available at the
current level of administration (administrative or advanced).
The following example shows the result of entering the environment help command at the storage system
command line. The command output displays the syntax help for the environment commands.
1440
Summary of Contents for AFF A700
