▪
env
is motherboard environmentals.
▪
fcache
is the Flash Cache adapter, also known as the Performance Acceleration Module 2.
▪
fcal
is a Fibre Channel-Arbitrated Loop device not connected to a storage device or Fibre
Channel network.
▪
fcvi
is the Fiber Channel Virtual Interface not connected to a Fibre Channel network.
▪
interconnect
or
nvram-ib
is the high-availability interface.
▪
mem
is system memory.
▪
nic
is a Network Interface Card not connected to a network.
▪
nvram
is nonvolatile RAM.
▪
nvmem
is a hybrid of NVRAM and system memory.
▪
sas
is a Serial Attached SCSI device not connected to a disk shelf.
▪
serviceproc
is the Service Processor.
▪
storage
is an ATA, FC-AL, or SAS interface that has an attached disk shelf.
▪
toe
is a TCP Offload Engine, a type of NIC.
◦
mb
specifies that all the motherboard devices are to be tested.
◦
slot
slotnum
specifies that a device in a specific slot number is to be tested.
◦
-name
device
specifies a given device class and type.
4. View the status of the test by entering the following command:
sldiag device status
Your storage system provides the following output while the tests are still running:
There are still test(s) being processed.
After all the tests are complete, the following response appears by default:
*> <SLDIAG:_ALL_TESTS_COMPLETED>
5. Verify that no hardware problems resulted from the addition or replacement of hardware components on
your storage system by entering the following command:
sldiag device status [-dev
devtype|mb|slotslotnum] [-name device] -long -state failed
The following example pulls up the full status of failures resulting from testing a newly installed FC-AL
adapter:
*> **sldiag device status -dev fcal -long -state failed**
TEST START ------------------------------------------
DEVTYPE: fcal
NAME: Fcal Loopback Test
1452
Summary of Contents for AFF A700
