c. Align the rubber cable retainer with the hole in the frame, push it in as far as it will go, and then rotate
the cable retainer 180° to the left to secure it.
d. Run the cable along the cabinet frame to the back of the cabinet.
6. Reinstall the cable conduit:
a. Slide the conduit over the PDU power cable and route the conduit along the system cabinet frame to
the PDU.
b. Install the conduit retaining clips from the other side of the cabinet over the conduit to secure it to the
cabinet frame.
7. Plug the badge cable back into the power supply, but do not reconnect the power supply to the power
source.
Reverse the door hinge and lock catch
When reversing the system cabinet door, you must move the system cabinet door hinge
and lock catch to the opposite front-side system cabinet upright.
You need the following tools:
• Phillips screwdriver
• 5 mm Allen wrench; magnetic Allen wrench is recommended
• Needle-nose pliers
• Step ladder so that you can easily access the Allen screws in the top hinge
1. Remove the screws securing the top hinge from the system cabinet frame, and set the screws and
hinge aside.
Be careful when removing the Allen screws to avoid dropping them into the cabinet
frame. Spare Allen screws are provided in the spares kit that shipped with your system
cabinet.
2. Remove the screws securing the bottom hinge from the system cabinet frame, and set the screws and
hinge aside.
1483
Summary of Contents for AFF A700
