4. Push the controller module all the way into the system, making sure that the cam handle clears the USB
flash drive, firmly push the cam handle to finish seating the controller module, and then push the cam
handle to the closed position.
The node begins to boot as soon as it is completely installed into the chassis.
5. Interrupt the boot process to stop at the LOADER prompt by pressing Ctrl-C when you see Starting
AUTOBOOT press Ctrl-C to abort….
If you miss this message, press Ctrl-C, select the option to boot to Maintenance mode, and then halt the
node to boot to LOADER.
6. Although the environment variables and bootargs are retained, you should check that all required boot
environment variables and bootargs are properly set for your system type and configuration using the
printenv bootarg name
command and correct any errors using the
setenv variable-name
<value>
command.
a. Check the boot environment variables:
▪
bootarg.init.boot_clustered
▪
partner-sysid
▪
bootarg.init.flash_optimized
for AFF C190/AFF A220 (All Flash FAS)
▪
bootarg.init.san_optimized
for AFF A220 and All SAN Array
▪
bootarg.init.switchless_cluster.enable
b. If External Key Manager is enabled, check the bootarg values, listed in the
kenv
ASUP output:
▪
bootarg.storageencryption.support <value>
▪
bootarg.keymanager.support <value>
▪
kmip.init.interface <value>
▪
kmip.init.ipaddr <value>
▪
kmip.init.netmask <value>
▪
kmip.init.gateway <value>
c. If Onboard Key Manager is enabled, check the bootarg values, listed in the
kenv
ASUP output:
▪
bootarg.storageencryption.support <value>
▪
bootarg.keymanager.support <value>
▪
bootarg.onboard_keymanager <value>
d. Save the environment variables you changed with the
savenv
command
e. Confirm your changes using the
printenv
variable-name
command.
7. Set your network connection type at the LOADER prompt:
◦
If you are configuring DHCP:
ifconfig e0a -auto
The target port you configure is the target port you use to communicate with the
impaired node from the healthy node during
var
file system restore with a network
connection. You can also use the e0M port in this command.
622
Summary of Contents for AFF A700
