◦
If you are configuring manual connections:
ifconfig e0a -addr=filer_addr -mask=netmask
-gw=gateway-dns=dns_addr-domain=dns_domain
▪
filer_addr is the IP address of the storage system.
▪
netmask is the network mask of the management network that is connected to the HA partner.
▪
gateway is the gateway for the network.
▪
dns_addr is the IP address of a name server on your network.
▪
dns_domain is the Domain Name System (DNS) domain name.
If you use this optional parameter, you do not need a fully qualified domain name in the netboot
server URL. You need only the server’s host name.
Other parameters might be necessary for your interface. You can enter
help ifconfig
at
the firmware prompt for details.
8. If the controller is in a stretch or fabric-attached MetroCluster, you must restore the FC adapter
configuration:
a. Boot to Maintenance mode:
boot_ontap maint
b. Set the MetroCluster ports as initiators:
ucadmin modify -m fc -t
initiator adapter_name
c. Halt to return to Maintenance mode:
halt
The changes will be implemented when the system is booted.
Boot the recovery image - AFF A700 and FAS9000
The procedure for booting the impaired node from the recovery image depends on
whether the system is in a two-node MetroCluster configuration.
Option 1 Boot the recovery image in most systems
You must boot the ONTAP image from the USB drive, restore the file system, and verify
the environmental variables.
This procedure applies to systems that are not in a two-node MetroCluster configuration.
Steps
1. From the LOADER prompt, boot the recovery image from the USB flash drive:
boot_recovery
The image is downloaded from the USB flash drive.
2. When prompted, either enter the name of the image or accept the default image displayed inside the
brackets on your screen.
3. Restore the
var
file system:
623
Summary of Contents for AFF A700
