cluster_B::> metrocluster show
Cluster Configuration State Mode
-------------------- ------------------- ---------
Local: cluster_B configured switchover
Remote: cluster_A configured waiting-for-switchback
The switchback operation is complete when the clusters are in the
normal
state.:
cluster_B::> metrocluster show
Cluster Configuration State Mode
-------------------- ------------------- ---------
Local: cluster_B configured normal
Remote: cluster_A configured normal
If a switchback is taking a long time to finish, you can check on the status of in-progress baselines by using
the
metrocluster config-replication resync-status show
command.
6. Reestablish any SnapMirror or SnapVault configurations.
Restore OKM, NSE, and NVE as needed - AFF A700 and FAS9000
Once environment variables are checked, you must complete steps specific to systems that have Onboard Key
Manager (OKM), NetApp Storage Encryption (NSE) or NetApp Volume Encryption (NVE) enabled.
Determine which section you should use to restore your OKM, NSE, or NVE configurations:
If NSE or NVE are enabled along with Onboard Key Manager you must restore settings you captured at the
beginning of this procedure.
• If NSE or NVE are enabled and Onboard Key Manager is enabled, go to
when Onboard Key Manager is enabled
• If NSE or NVE are enabled for ONATP 9.5, go to
Option 2: Restore NSE/NVE on systems running ONTAP
• If NSE or NVE are enabled for ONTAP 9.6, go to
Option 3: Restore NSE/NVE on systems running ONTAP
Option 1: Restore NVE or NSE when Onboard Key Manager is enabled
Steps
1. Connect the console cable to the target node.
2. Use the
boot_ontap
command at the LOADER prompt to boot the node.
3. Check the console output:
628
Summary of Contents for AFF A700
