Do not use the numbered and lettered I/O cam latch to eject the core dump module. The
numbered and lettered I/O cam latch ejects the entire NVRAM10 module and not the
core dump module.
c. Rotate the cam handle until the core dump module begins to slide out of the NVRAM10 module.
d. Gently pull the cam handle straight toward you to remove the core dump module from the NVRAM10
module and set it aside.
Be sure to support the core dump module as you remove it from the NVRAM10 module.
3. Install the core dump module:
a. If you are installing a new core dump module, remove the blank module from slot 6-1.
b. Align the edges of the core dump module with the opening in the NVRAM10 module.
c. Gently push the core dump module into the bay until the cam handle engages.
d. Rotate the cam handle until it locks into place.
Step 4: Reboot the controller after FRU replacement
After you replace the FRU, you must reboot the controller module.
Step
1. To boot ONTAP from the LOADER prompt, enter
bye
.
Step 5: Switch back aggregates in a two-node MetroCluster configuration
After you have completed the FRU replacement in a two-node MetroCluster configuration, you can perform the
MetroCluster switchback operation. This returns the configuration to its normal operating state, with the sync-
source storage virtual machines (SVMs) on the formerly impaired site now active and serving data from the
local disk pools.
This task only applies to two-node MetroCluster configurations.
Steps
1. Verify that all nodes are in the
enabled
state:
metrocluster node show
641
Summary of Contents for AFF A700
