::> system controller slot module replace -node node1 -slot 6-2
Warning: NVMe module in slot 6-2 of the node node1 will be powered
off for replacement.
Do you want to continue? (y|n): `y`
The module has been successfully powered off. It can now be
safely replaced.
After the replacement module is inserted, use the "system
controller slot module insert" command to place the module into
service.
iii. Display the slot status with the system controller slot module show command.
The NVMe slot status displays waiting-for-replacement in the screen output for the caching module
that needs replacing.
b. For ONTAP 9.8 and later:
i. Record the caching module capacity, part number, and serial number on the target node:
system
node run local sysconfig -av 6
ii. In admin privilege level, prepare the target NVMe slot for removal, responding
y
when prompted
whether to continue:
system controller slot module remove -node node_name
-slot slot_number
The following command prepares slot 6-2 on node1 for removal, and
displays a message that it is safe to remove:
::> system controller slot module remove -node node1 -slot 6-2
Warning: SSD module in slot 6-2 of the node node1 will be powered
off for removal.
Do you want to continue? (y|n): `y`
The module has been successfully removed from service and powered
off. It can now be safely removed.
iii. Display the slot status with the
system controller slot module show
command.
The NVMe slot status displays
powered-off
in the screen output for the caching module that
needs replacing.
See the
for your version of ONTAP for more details.
4. Remove the caching module:
644
Summary of Contents for AFF A700
