replace a failed NVRAM module or the DIMMs inside the NVRAM module. To replace a
failed NVRAM module, you must remove it from the chassis, remove the FlashCache
module or modules from the NVRAM module, move the DIMMs to the replacement
module, reinstall the FlashCache module or modules, and install the replacement
NVRAM module into the chassis. Because the system ID is derived from the NVRAM
module, if replacing the module, disks belonging to the system are reassigned to the new
system ID.
Before you begin
• All disk shelves must be working properly.
• If your system is in an HA pair, the partner node must be able to take over the node associated with the
NVRAM module that is being replaced.
• This procedure uses the following terminology:
◦
The
impaired
node is the node on which you are performing maintenance.
◦
The
healthy
node is the HA partner of the impaired node.
• This procedure includes steps for automatically or manually reassigning disks to the controller module
associated with the new NVRAM module. You must reassign the disks when directed to in the procedure.
Completing the disk reassignment before giveback can cause issues.
• You must replace the failed component with a replacement FRU component you received from your
provider.
• You cannot change any disks or disk shelves as part of this procedure.
Step 1: Shut down the impaired controller
You can shut down or take over the impaired controller using different procedures,
depending on the storage system hardware configuration.
709
Summary of Contents for AFF A700
