Make sure that you support the bottom of the controller module as you slide it out of the chassis.
7. Place the controller module on a stable, flat surface, and then open the air duct:
a. Press in the locking tabs on the sides of the air duct toward the middle of the controller module.
b. Slide the air duct toward the fan modules, and then rotate it upward to its completely open position.
Air duct locking tabs
Risers
Air duct
Step 2: Move the NVRAM card
As part of the controller replacement process, you must remove the NVRAM card from
Riser 1 in the impaired controller module and install the card into Riser 1 of the
replacement controller module. You should only reinstall Riser 1 into the replacement
controller module after you have moved the DIMMs from the impaired controller module
to the replacement controller module.
1. Remove the NVRAM riser, Riser 1, from the controller module:
a. Rotate the riser locking latch on the left side of the riser up and toward the fans.
The NVRAM riser raises up slightly from the controller module.
b. Lift the NVRAM riser up, shift it toward the fans so that the sheet metal lip on the riser clears the edge
of the controller module, lift the riser straight up out of the controller module, and then place it on a
776
Summary of Contents for AFF A700
