INSTALLATION GUIDE :
4. PRESENTATION OF THE APPLIANCES
Copyright NETASQ 2010
Page 20/66
NOTE
: power is supplied to this appliance from inside the rear panel. An upgrade to version 8.0
is recommended.
4
4
.
.
6
6
T
T
h
h
e
e
U
U
4
4
5
5
0
0
a
a
p
p
p
p
l
l
i
i
a
a
n
n
c
c
e
e
The U450 appliance has the following characteristics:
Throughput of 1000 Mbits/s.
600,000 concurrent connections.
15 Gigabit interfaces.
10,500 new sessions per second.
1. Software
shutdown
button.
2. LEDs from bottom to top: Power/Status/Online.
3. Serial port: for connecting the firewall directly to a PC or modem.
4. PS2 mini-din port: for connecting a keyboard.
5. VGA port: for connecting a monitor.
6. Button to reset to the default configuration (defaultconfig).
7. 1 USB port: for secure configuration or updates.
8. OUT
Interface.
9. IN
Interface.
Point 1
: to shut down the software, hold down the software shutdown button for 4 seconds (until the
Online
(green) LED goes off).
NOTE
: The fan is directly linked to the power supply.
Point 2:
the
Power
LED (yellow) indicates that the product has been plugged in but has been shut down. If
this is the only LED that lights up, this means that the appliance is off.
The product is running when the
Power
LED and the
Status
and
Online
LEDs (green) are visible. The
Online
LED will be the last to light up when the product is running. Traffic will pass through the interfaces.
When the appliance is starting, shutting down or being updated, only the
Status
and
Power
LEDs will light
up.
WARNING
You are strongly advised against unplugging the product when the
Status
LED is starting, shutting
down or being updated.
The
Status
LED will blink (quick blinking every 250 milliseconds) in the event of a major failure of the product
(hardware modification, faulty network interface, etc). In this case, do contact your distributor.
1
6
8
2 3
4
5
7
9
