Web Graphical User In-
terface (GUI) for ESMS
200
5. In the
Network Privilege
field, enter the network privilege assigned to the user which could be
Administrator, Operator, User or No Access.
6. Check the
SNMP Status
check box to enable SNMP access for the user.
Password field is mandatory, if SNMP Status is enabled.
7. Choose the SNMP Access level option for user from the
SNMP Access
dropdown list. Either it
can be Read Only or Read Write.
8. Choose the
Authentication Protocol
to use for SNMP settings from the drop down list.
Password field is mandatory, if Authentication protocol is changed.
9. Choose the Encryption algorithm to use for SNMP settings from the
Privacy protocol
drop-
down list.
10.In the
Email ID
field, enter the email ID of the user. If the user forgets the password, the new
password will be mailed to the configured email address.
SMTP Server must be configured to send emails.
• Email Format: Two types of formats are available:
a. AMI-Format: The subject of this mail format is
Alert from (your Hostname)
. The mail con-
tent shows sensor information, ex: Sensor type and Description.
b. Fixed-Subject Format: This format displays the message according to user’s setting. You
must set the subject and message for email alert.
11.In the
New SSK Key
field, click Browse and select the SSH key file.
SSH key file should be of pub type.
12.Click
Add
to save the new user and return to the users list.
13.Click
Cancel
to cancel the modification and return to the users list.
Modify an existing user:
14.Select an existing user from the list and click
Modify User
. This opens the Add User screen as
shown in the screenshot below.
Summary of Contents for Demos R130 M2
