Installing hardware
55
2.12. Point to point backplane
2.12.1. Removing the HDD Backplane (3.5” HDD SKU)
Prerequisite: Remove the HDDs. See ???. Remove the top cover. See ???.
1. Disconnect the following cables from the HDD BP:
Figure 2.51. HDD BP Connectors
a.
Device 0 Connector connect to HDD 0
b.
Device 1 Connector connect to HDD 1
c.
Device 2 Connector connect to HDD 2
d.
Device 3 Connector connect to HDD 3
e.
10 pin Power connector for BP with +12V, +5V, +3.3V
f.
IPMB connector lining to on board BMC controller FAN Speed
g.
SGPIO connector for HDD LED Decode.
h.
System FAN 0 for CPU 0 Block
i.
System FAN 1 for CPU 0 Block
j.
System FAN 2 for CPU 0 Block
k.
System FAN 3 for CPU 1 Block
l.
System FAN 4 for CPU 1 Block
m.
System FAN 5 for CPU 1 Block
2. Remove five (5) screws from the HDD backplane.
Figure 2.52. Removing the 3.5” HDD Backplane Screws
3. Remove the HDD backplane from the chassis.
Summary of Contents for Demos R130 M2
