BIOS
104
Left and right
arrows
Select Menu
The left and right arrow keys are used to move between the ma-
jor menu pages. The keys have no affect if a sub-menu or pick
list is displayed.
<Tab>
Select Field
The <Tab> key is used to move between fields. For example,
<Tab> can be used to move from hours to minutes in the time
item in the main menu.
-
Change Value The minus key on the keypad is used to change the value of the
current item to the previous value. This key scrolls through the
values in the associated pick list without displaying the full list.
+
Change Value The plus key on the keypad is used to change the value of the
current menu item to the next value. This key scrolls through the
values in the associated pick list without displaying the full list.
On 106-key Japanese keyboards, the plus key has a different
scan code than the plus key on the other keyboard, but will have
the same effect.
F8
Previous Val-
ues
Pressing <F8> makes the following message to appear:
Load Previous Values?
Yes/No
If Yes is highlighted and <Enter> is pressed, all Setup fields are
set to their previous values. If No is highlighted and <Enter> is
pressed, or if the <Esc> key is pressed, the user is returned to
where they were before <F8> was pressed without affecting any
existing field values.
F9
Setup Defaults Pressing <F9> makes the following message to appear:
Load Optimized Defaults?
Yes/No
If Yes is highlighted and <Enter> is pressed, all Setup fields are
set to their default values. If No is highlighted and <Enter> is
pressed, or if the <Esc> key is pressed, the user is returned to
where they were before <F9> was pressed without affecting any
existing field values.
F10
Save and Exit Pressing <F10> makes the following message to appear:
Save configuration and exit?
Yes/No
If Yes is highlighted and <Enter> is pressed, all changes are
saved and Setup is exited. If No is highlighted and <Enter> is
pressed, or the <Esc> key is pressed, the user is returned to
where they were before <F10> was pressed without affecting
any existing values.
Summary of Contents for Demos R420 M2
