NP727 User’s Manual V1.00
4.3.3 Configuration Save & Restore
This function is used to backup and to restore the THE NP727 settings. The THE NP727 can also be restored to
the factory default settings using this function. It can be used to duplicate settings to other access points (backup
settings of this system and then restore on another AP).
y
Reset to Default:
Click
Reset
to load the factory default settings of THE NP727. Then, reboot the system to
let the default settings take effect.
y
Backup Settings:
Click
Save
to save the current system configurations to a backup file on a local disk. It is
recommended to make a backup before any configuration changes are made.
y
Restore Settings:
Click
Browse
to select a configuration file to restore, and then, press
Upload
to proceed.
The configuration file will replace the active configuration file currently running on the system. Reboot the
system to let the parameter changes take effect
.
After network parameters have been reset/restored, the network settings of the administrator PC may
need to be changed to ensure that the IP address of the administrator PC is on the same subnet mask as
THE NP727.
Summary of Contents for INFRASTRUCTURE SERIES
Page 1: ...NetComm INFRASTRUCTURE Series In wall Wireless Access Point USER GUIDE...
Page 3: ...NP727 User s Manual V1 00 4 5 3 Repeater Information 62 4 5 4 Event Log 61 4 6 Online Help 62...
Page 13: ...NP727 User s Manual V1 00 Step 4 Cover it with faceplate...
Page 51: ...NP727 User s Manual V1 00 Layer 2 Firewall Overview Check State...