NB6, NB6W, NB6Plus4W
User Guide
YML854Rev1
1
www.netcomm.com.au
for general users, they may only need or want to learn about error, critical, alert, or emergency
messages only. The default Display Level is
Error
.
Therefore, when the log level is “Debugging” and the display level is “Error”, the CPE logs the most
detailed message but shows error level data only.
Mode:
You can choose where to store the logs; the options include
Local
,
Remote
and
Both
. Local means
the CPE, i.e., the ADSL Router. Remote means the log server you specified to forward the log
information to. The default mode is Local.
If you choose
Remote
or
Both
, you have to specify the
Server IP Address
and
UDP Port
, and all the
events will be sent to the specified UDP port of the specified log server.
Note: Display Level only filters for the local side. All the messages will be displayed on the remote Log Server.
example
Suppose we are going to record the system logs on both the ADSL Router and the Server bearing IP address
10.11.95.2, the procedures below illustrate the situation:
System Log Configuration
1.
Choose
Enabled
Log.
2.
Select Debugging as the
Log Level
, and Error as the
Display Level
. (Or select other level according to
your needs.)
3.
Set the
Mode
as Both, key in the
Server IP Address
as 10.11.95.2, and leave the
Server UDP Port
as
the default value 514.
4.
Press
Apply
to invoke the settings.
