NTC-402
–
Telstra Private IP WAN Configuration Guide
9 of 11
CG01068 v. 1.0 October 2018
© NetComm Wireless 2018
Remote Administrator Host Definition
Separate definitions must be created for HTTP and HTTPS.
Before any changes can be made you must click the Edit button.
I T E M
D E S C R I P T I O N
T E L S T R A S E T T I N G S
ID No.
System generated reference number.
N/A
Interface
Default is All WAN.
All WAN
Protocol
To access the broadest range of web services, create one definition for
HTTP and one for HTTPS.
HTTP, HTTPS
IP
Any IP allows unlimited access to all URLs using the selected Protocol.
If you select Specific IP enter its IP address in the filed provided. You
must create a separate Host Definition for each specific address.
Any IP
Subnet Mask This is unnecessary (N/A) if the IP is set to Any IP.
For each Specific IP address, select an appropriate Subnet Mask from
the drop down menu.
N/A
Service Port
For HTTP the default port is: 80
For HTTPS the default port is: 443
For HTTP: 80
For HTTPS: 443
Enable
Select
Enable to activate the definition.
Action
Click the Edit button to enable changes to the definition.
Click Edit
Table 5
–
Remote Administrator configuration
12
Click the Save button to apply the changes you have made.
Enable Telnet, SSH and HTTP/S WAN
13
Open Administration >> Configure & Manage and click the Telnet & SSH tab:
Figure 6
–
Telnet & SSH settings
14
For Telnet make the following settings:
a
Select LAN
Enable
b
Select WAN
Enable
c
Set the Service Port to 23
15
For SSH (Secure SHell) make the following settings:
a
Select LAN
Enable
