UM-00006 v1.1
www.netcommwireless.com
NTC-8000 – M2M Multi-Port Network Gateway
21
Band / Provider
The band settings page enables you to select which frequency band you will use for your connection and enables you to scan for
available network operators in your area.
Figure 14 - Band / Provider Selection
You may want to do this if you’re using the gateway in a country with multiple frequency networks that may not all support HSPA.
You can configure the gateway to only connect on the network frequencies that suit your requirements. Make your selection from
the Change Band drop down list. In most cases, the default setting of All bands is appropriate.
You can also scan for available 3G service providers in your area by setting the Current Operator Selection Mode to Manual and
then clicking the Scan button.
Figure 15 - Manual Operator Selection
A list of the detected mobile broadband service carriers in your area will be displayed. Select the most appropriate mobile
broadband service from the list shown and click Apply. In most cases, the default setting of Automatic is appropriate.