User’s Manual
Wireless Serial Server GW5120
Copyright © 2009 Neteon Technologies, Inc.
All rights reserved.
4
3. Initial
IP
Configuration
Unit basic settings will be covered in this chapter.
3.1. Default Settings
The GW5120 has two IP addresses one for Ethernet interface and another one for wireless network
interface. These default settings are shown from under information
Default IP addresses
Interface
Device IP
Subnet mask
Gateway IP
LAN port
10.0.50.100
255.255.0.0
10.0.0.254
WLAN Port
192.168.1.1
255.255.255.0
192.168.1.254
The other default settings of GW5120 are shown in the following table
Property
Default Value
Ethernet Port
IP Address
10.0.50.100
Gateway
10.0.0.254
Subnet Mask
255.255.0.0
WLAN Port
IP Address
192.168.1.100
Gateway
192.168.1.254
Subnet Mask
255.255.255.0
Security
User Name
Admin
Password
Null
(Leave it blank)
Serial
COM
9600/None/ 8/1,No flow control, packet delimiter disabled
Link Mode
TCP Server, Listen port 4660/4661,No Filter, Virtual COM disabled
SNMP
SysName of SNMP
Name
SysLocation of SNMP
Location
SysContact of SNMP
Contact
Table 1. Default settings of the GW5120 device
NOTE: Unit can be reset to factory default by pressing the reset button for 5
seconds.
Warning: Do NOT set LAN and WLAN IP addresses in the same subnet. That may
cause unexpected networking problem.