FXS Gateway Overview
- 88 -
LABEL
DESCRIPTION
(FXS+FXO)
will be failed if users configure it too long
(FXO Only)
.
Ring Before
Answer
(FXS+FXO)
This will help the users to answer the calls from PSTN into
this gateway quickly. The call will be connected by one
time ring if users configure this for 1. From 1 to 10
(FXO
Only)
.
Delay to add DTMF
(FXO)
The timer for the DTMF signal sending if the calls are from
the IP to PSTN side. It could only support the
one-stage-dialing function
(FXO Only)
.
Auto connect time
(FXO)
The FXO will send the connect message to the IP side is
this timer is up in the one-stage-dialing function. It could
only support the one-stage-dialing function
(FXO Only)
.
FXO Type
(FXS+FXO)
Users could configure the entire calls need the 2nd stage
dialing or not. Normal: The 1st or 2nd stage dialing will
depend on the dialing plan from the users. If user dial the
number of the FXO port, that will be the 2nd stage dialing.
Force 2nd dial: Every call will need the 2nd stage dialing
type
(FXO Only)
.
Summary of Contents for 1AFXS
