Command with FXS Gateway
- 129 -
Application Version 200 supports PPPoE function for user to set up the login ID
and password to connect to Internet. Please refer to PPPoE mode
for how to set up
PPPoE.
24.3.2
Application Mode Configuration
It is including Basic mode, such as Gatekeeper and Peer-to-Peer, and Advanced
mode, such as Hotline mode and IP-Sharing mode. It will be detailed in the next
Chapter.
24.3.3
Saving Your Configuration
Save the change of configurations for Gateway and apply the new configurations
by rebooting the device.
Step 1. Confirm the changed configurations, input [commit] and press [enter] key to
save it.
Step 2. Input [reboot] then press [enter] key to restart Gateway.
Step 3. After around 40 seconds, Gateway will take effect in new configurations.
These commands save all system configuration into nonvolatile memory.
Nonvolatile memory refers to the Gateway storage that remains even if the Gateway
power is turned of. Run Time (memory) is lost when the Gateway power is turned off.
You must use the command to save any configuration that you make, otherwise the
Gateway will return to its default setting when it is restarted.
Summary of Contents for 1AFXS
