Command with FXS Gateway
- 130 -
Do not turn off your Gateway or remove the Gateway
while saving your configuration.
24.4 Application modes
This Chapter will introduce the four application modes users often use.
Particularly the Gatekeeper and Peer-to-Peer mode are the basic application mode.
User would like to set as advanced application mode, such as Hotline Mode and
Behind IP-Sharing mode, please refer to the basic application mode for more
information.
24.4.1
Gatekeeper mode
User has to prepare a Gatekeeper Program. To assign a gatekeeper address for
Gateway, and define it’s own registered ID and phone number. For detail, please refer
to [h323] command.
Several important H323 parameters are listed below when setting gatekeeper
mode: [–gk], [gwtype], [-prefix], [–line1], [–line2], [–line3], and [–line4].
Step 1.
Setting gatekeeper mode, and line number
usr/config$ h323 –mode 0 (default gatekeeper mode)
usr/config$ h323 –gk 192.168.1.1 –prefix 1 –line1 11 –line2 12 –line3 13 –line4
14
Summary of Contents for 1AFXS
