Command with FXS Gateway
- 133 -
usr/config$ commit
usr/config$ reboot
24.4.2
Peer-to-Peer Mode
Peer-to-Peer Mode allows users to call other VoIP devices without using a
gatekeeper. When in Peer-To-Peer mode, Gateway will send SETUP message
directly to the destination IP address once the dial is finished. Users have 2 methods
of dial. One is IP Address dialing, and the other is [Phone Book] dial, which we will
describe later. When using IP address as destination phone number, press [*] as [.] in
IP address expression, and press [#] when dial is finished.
When using Phone Book, users can dial predefined phone number, and press [#]
as end of dial.
To configure Peer-To-Peer Mode in Gateway, follow the steps below:
Step 1.
Set Peer-To-Peer Mode, using [h323] command
usr/config$ h323 –mode 1 (Peer To Peer mode)
For example:
usr/config$ h323 –print
Summary of Contents for 1AFXS
