Internet Configuration
10
N300 Wireless ADSL2+ Modem Router DGN2200Mv2
Fixed IP (Static) Account Setup
1.
Select
Basic Settings
from the router menu.
2.
If required, enter the account name and domain name from your ISP.
3.
Select
Use Static IP Address
or
Use IP Over ATM
(IPoA — RFC1483 Routed) according
to the information from your ISP. If you select IPoA, the router will detect the gateway IP
address, but you still need to provide the router IP address.
4.
Enter your assigned IP address, subnet mask, and the IP address of your ISP’s gateway
wireless modem router. This information should have been provided to you by your ISP.
5.
Enter the IP address of your ISP’s primary DNS server. If a secondary DNS server address
is available, enter it also. DNS servers translate an Internet name such as
www.netgear.com
to a numeric IP address.
Manual Setup
In order to connect to the network, an active broadband service account is required. Contact
your ISP for your user name, password, and the network name. You must also configure
some or all of the settings described in the following sections, depending on how you have
chosen to connect to the Internet:
• 3G Mobile Broadband Settings
The following sections provide instructions for each of these procedures.
Broadband Settings
To configure your broadband Internet settings manually:
1.
Select
Broadband Settings
.
