LAN Configuration
103
NETGEAR ProSAFE VPN Firewall FVS318G v2
DHCPv6 for DMZ Connected Computers
DHCP Status
Specify the status of the DHCPv6 server:
•
Disable DHCPv6 Server
. This is the default setting, and the DHCPv6 fields are
masked out.
•
Enable the DHCPv6 Server
. If you enable the server, you must complete the
DHCPv6 fields.
DHCP Mode
Select a DHCPv6 mode:
•
Stateless
. The IPv6 clients generate their own IP address
by using a combination of locally available information and
router advertisements but receive DNS server information
from the DHCPv6 server. For stateless DHCPv6, you must
configure the RADVD and advertisement prefixes (see
Configure the IPv6 Router Advertisement Daemon and
Advertisement Prefixes for the DMZ
on page 106).
•
Stateful
. The IPv6 clients obtain an interface IP address,
configuration information such as DNS server information,
and other parameters from the DHCPv6 server. The IP
address is a dynamic address. (see
IPv6 DMZ Address
Pools
on page 104).
Domain Name
Enter the domain name of the DHCP server.
Server Preference Enter the DHCP server preference value. The possible values
are 0–255, with 255 as the default setting.
This is an optional setting that specifies the server’s preference
value in a server advertise message. The client selects the
server with the highest preference value as the preferred
server.
Table 19. DMZ Setup screen settings for IPv6 (continued)
Setting
Description
