Virtual Private Networking Using IPSec and L2TP Connections
215
NETGEAR ProSAFE VPN Firewall FVS318G v2
3.
To view the wizard default settings, in the upper right of the screen, click the
VPN Wizard
default values
option arrow.
4.
Complete the settings as described in the following table:
Table 41. IPSec VPN Wizard settings for an IPv4 gateway-to-gateway tunnel
Setting
Description
About VPN Wizard
This VPN tunnel will connect
to the following peers
Select the
Gateway
radio button. The local WAN port’s IP address or
Internet name displays in the End Point Information section.
Connection Name and Remote IP Type
What is the new Connection
Name?
Enter a descriptive name for the connection. This name is used to help you
to manage the VPN settings; the name is not supplied to the remote VPN
endpoint.
What is the pre-shared key?
Enter a pre-shared key. The key must be entered both here and on the
remote VPN gateway. This key must be a minimum of 8 characters and
must not exceed 49 characters.
End Point Information
a
What is the Remote WAN’s IP
Address or Internet Name?
Enter the IPv4 address or Internet name (FQDN) of the WAN interface on
the remote VPN tunnel endpoint.
What is the Local WAN’s IP
Address or Internet Name?
When you select the
Gateway
radio button in the About VPN Wizard
section, the IPv4 address of the VPN firewall’s active WAN interface is
automatically entered.
