Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
8-8
GARP, GVRP, and GMRP Commands
v1.0, February 2007
8.3.2 set gmrp interfacemode
This command enables GARP Multicast Registration Protocol. If an interface which has
GARP enabled is enabled for routing or is enlisted as a member of a port-channel (LAG),
GARP functionality is disabled on that interface. GARP functionality is subsequently re-
enabled if routing is disabled and port-channel (LAG) membership is removed from an
interface that has GARP enabled.
Default
disabled
Format
set gmrp interfacemode
Modes
Interface Config
Global Config
8.3.2.1 no set gmrp interfacemode
This command disables GARP Multicast Registration Protocol. If an interface which has
GARP enabled is enabled for routing or is enlisted as a member of a port-channel (LAG),
GARP functionality is disabled. GARP functionality is subsequently re-enabled if routing
is disabled and port-channel (LAG) membership is removed from an interface that has
GARP enabled.
Format
no set gmrp interfacemode
Modes
Interface Config
Global Config
8.3.3 show gmrp configuration
This command displays GARP information for one or all interfaces.
Format
show gmrp configuration {<slot/port> | all}
Modes
Privileged EXEC
User EXEC
Interface
This displays the
slot/port
of the interface that this row in the
table describes.
Join Timer
Specifies the interval between the transmission of GARP
PDUs registering (or re-registering) membership for an
attribute. Current attributes are a VLAN or multicast group.
There is an instance of this timer on a per-port, per-GARP
participant basis. Permissible values are 10 to 100 centisec-
onds (0.1 to 1.0 seconds). The factory default is 20 centisec-
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
