Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
10-2
SNMP Commands
v1.0, February 2007
10.1.2 snmp-server community
This command adds (and names) a new SNMP community. A community
<name>
is a
name associated with the switch and with a set of SNMP managers that manage it with a
specified privileged level. The length of
<name>
can be up to 16 case-sensitive characters.
Default
public and private, which you can rename; default values for
the remaining four community names are blank
Format
snmp-server community <name>
Mode
Global Config
10.1.2.1 no snmp-server community
This command removes this community name from the table. The
<name>
is the
community name to be deleted.
Format
no snmp-server community <name>
Mode
Global Config
10.1.3 snmp-server community ipaddr
This command sets a client IP address for an SNMP community. The address is the
associated community SNMP packet sending address and is used along with the client IP
mask value to denote a range of IP addresses from which SNMP clients may use that
community to access the device. A value of 0.0.0.0 allows access from any IP address.
Otherwise, this value is ANDed with the mask to determine the range of allowed client IP
addresses. The name is the applicable community name.
Default
0.0.0.0
Format
snmp-server community ipaddr <ipaddr> <name>
Mode
Global Config
Note:
Community names in the SNMP Community Table must be unique. When
making multiple entries using the same community name, the first entry is
kept and processed and all duplicate entries are ignored.
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
