Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
11-4
Port-Based Access and Authentication Commands
v1.0, February 2007
11.1.7 dot1x max-req
This command sets the maximum number of times the authenticator state machine on this
port will transmit an EAPOL EAP Request/Identity frame before timing out the
supplicant. The
<count>
value must be in the range 1 - 10.
Default
2
Format
dot1x max-req
<count>
Mode
Interface Config
11.1.7.1 no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this
port will transmit an EAPOL EAP Request/Identity frame before timing out the
supplicant.
Format
no dot1x max-req
Mode
Interface Config
11.1.8 dot1x port-control
This command sets the authentication mode to be used on the specified port. The control
mode may be one of the following.
force-unauthorized:
The authenticator PAE unconditionally sets the controlled port to
unauthorized.
force-authorized:
The authenticator PAE unconditionally sets the controlled port to
authorized.
auto:
The authenticator PAE sets the controlled port mode to reflect the outcome of the
authentication exchanges between the supplicant, authenticator and the authentication
server.
Default
auto
Format
dot1x port-control {force-unauthorized | force-
authorized | auto}
Mode
Interface Config
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
