Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Port-Based Access and Authentication Commands
11-5
v1.0, February 2007
11.1.8.1 no dot1x port-control
This command sets the authentication mode to be used on the specified port to 'auto'.
Format
no dot1x port-control
Mode
Interface Config
11.1.9 dot1x port-control all
This command sets the authentication mode to be used on all ports. The control mode may
be one of the following modes:
•
force-unauthorized
— The authenticator PAE unconditionally sets the controlled
port to unauthorized.
•
force-authorized
— The authenticator PAE unconditionally sets the controlled port to
authorized.
•
auto
— The authenticator PAE sets the controlled port mode to reflect the outcome of
the authentication exchanges between the supplicant, authenticator and the
authentication server.
Default
auto
Format
dot1x port-control all {force-unauthorized |
force-authorized | auto}
Mode
Global Config
11.1.9.1 no dot1x port-control all
This command sets the authentication mode to be used on all ports to 'auto'.
Format
no dot1x port-control all
Mode
Global Config
11.1.10 dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command
is only valid if the control mode for the specified port is 'auto'. If the control mode is not
'auto' an error will be returned.
Format
dot1x re-authenticate <slot/port>
Mode
Privileged EXEC
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
