Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Port-Based Access and Authentication Commands
11-15
v1.0, February 2007
11.2.2.1 no radius server host
This command is used to remove the configured RADIUS authentication server or the
RADIUS accounting server. If the 'auth' token is used, the previously configured RADIUS
authentication server is removed from the configuration. Similarly, if the 'acct' token is
used, the previously configured RADIUS accounting server is removed from the
configuration. The
<ipaddr>
parameter must match the IP address of the previously
configured RADIUS authentication / accounting server.
Format
no radius server host {auth | acct} <ipaddress>
Mode
Global Config
11.2.3 radius server key
This command is used to configure the shared secret between the RADIUS client and the
RADIUS accounting / authentication server. Depending on whether the 'auth' or 'acct'
token is used, the shared secret is configured for the RADIUS authentication or RADIUS
accounting server. The IP address provided must match a previously configured server.
When this command is executed, the secret is prompted.
Format
radius server key {auth | acct} <ipaddr>
Mode
Global Config
11.2.4 radius server msgauth
This command enables the message authenticator attribute for a specified server.
Format
radius server msgauth <ipaddr>
Mode
Global Config
11.2.4.1 no radius server msgauth
This command disables the message authenticator attribute for a specified server.
Format
no radius server msgauth <ipaddr>
Mode
Global Config
Note:
The secret must be an alphanumeric value not exceeding 16 characters.
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
