Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
15-32
System Maintenance Commands
v1.0, February 2007
15.7 Dumping System Information
The
show tech-support
command dumps all major system information into a file that can
be sent to NETGEAR product support for debugging purposes. The command output is
not displayed on the console. Use the
copy
command to transfer the dumped file to the
host PC.
Format
show tech-support
Mode
Global Config
15.8 Setting the Output Length of show running-config
By default, the output of the
show running-config
command pauses after every 18 lines
of output. If you do not want the output to pause or you want to change the number of lines
displayed, the following commands are provided to control output behavior.
15.8.1 terminal length
This command specifies how many lines of output to display on the console before
pausing. When the value of 0 is used, the output will not pause.
Format
terminal length
<0-24>
Mode
Global Config
15.8.2 terminal no length
This command resets the number of lines displayed by the
show running-config
command before pausing to the default value of 18.
Format
terminal no length
Mode
Global Config
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
