Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
3-16
Administrative Access Commands
v1.0, February 2007
3.5.3 sshcon maxsessions
This command specifies the maximum number of SSH connection sessions that can be
established. A value of 0 indicates that no ssh connection can be established. The range is
0 to 5.
Default
5
Format
sshcon maxsessions <0-5>
Mode
Privileged EXEC
3.5.3.1 no sshcon maxsessions
This command sets the maximum number of allowed SSH connection sessions to the
default value.
Format
no sshcon maxsessions
Mode
Privileged EXEC
3.5.4 sshcon timeout
This command sets the SSH connection session timeout value, in minutes. A session is
active as long as the session has been idle for the value set. The time is a decimal value
from 1 to 160.
Changing the timeout value for active sessions does not become effective until the session
is re accessed. Also, any keystroke activates the new timeout duration.
Default
5
Format
sshcon timeout <1-160>
Mode
Privileged EXEC
3.5.4.1 no sshcon timeout
This command sets the SSH connection session timeout value, in minutes, to the default.
Changing the timeout value for active sessions does not become effective until the session
is re accessed. Also, any keystroke activates the new timeout duration.
Format
no sshcon timeout
Mode
Privileged EXEC
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
