Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Administrative Access Commands
3-21
v1.0, February 2007
3.7.2 users passwd
Use this command to change a password. Passwords are a maximum of eight
alphanumeric characters. If a user is authorized for authentication or encryption is
enabled, the password length must be at least eight alphanumeric characters. The
username and password are not case-sensitive. When you change a password, a prompt
asks for the old password. If there is no password, press enter.
Default
no password
Format
users passwd <username>
Mode
Global Config
3.7.2.1 no users passwd
This command sets the password of an existing user to blank. When you change a
password, a prompt asks for the old password. If there is no password, press enter.
Format
no users passwd <username>
Mode
Global Config
3.7.3 users snmpv3 accessmode
This command specifies the snmpv3 access privileges for the specified login user. The
valid accessmode values are
readonly
or
readwrite
. The
<username>
is the login user
name for which the specified access mode applies. The default is
readwrite
for the
“admin” user and
readonly
for all other users
Default
admin - readwrite; other - readonly
Format
users snmpv3 accessmode <username> {readonly |
readwrite}
Mode
Global Config
3.7.3.1 no users snmpv3 accessmode
This command sets the snmpv3 access privileges for the specified user as
readwrite
for
the “admin” user and
readonly
for all other users. The
<username>
value is the user name
for which the specified access mode will apply.
Format
no users snmpv3 accessmode <username>
Mode
Global Config
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
