Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Port and System Setup Commands
4-7
v1.0, February 2007
Format
no monitor session <session-id>
Mode
Global Config
4.1.14 no monitor
This command removes all the source ports and a destination port and restores the default
value for mirroring session mode for all the configured sessions.
Default
enabled
Format
no monitor
Mode
Global config
4.1.15 show monitor session
This command displays the port monitoring information for the system. The
<sessionid>
parameter is an integer.
Format
show monitor session <sessionid>
Mode
Privileged EXEC
Session ID
The session identifying number.
Admin Mode
Indicates whether the Port Monitoring feature is enabled or
disabled. The possible values are enable and disable.
Probe Port
The interface configured as the probe port.
Mirrored Port
The interface configured as the mirrored port.
4.1.16 show port
This command displays port information.
Format
show port {<slot/port> | all}
Mode
Privileged EXEC
Interface
Valid slot and port number separated by forward slashes.
Type
If not blank, this field indicates that this port is a special type
of port. The possible values are:
Note:
This is a stand-alone “no” command. This command does not have a
“normal” form.
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
