Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
4-16
Port and System Setup Commands
v1.0, February 2007
Port
Server Port Number
Last Attempt
Time
Last server attempt time for the specified server.
Last Attempt
Status
Last server attempt status for the server.
Total Unicast
Requests
Number of requests to the server.
Failed Unicast
Requests
Number of failed requests from server.
4.3.12 clock timezone
When using SNTP/NTP time servers to update the switch’s clock, the time data received
from the server is based on Coordinated Universal Time (UTC) which is the same as
Greenwich Mean Time (GMT). This may not be the time zone in which the switch is
located. Use the
clock timezone
command to configure a time zone specifying the number
of hours and optionally the number of minutes difference from UTC. To set the switch
clock to UTC, use the
no
form of the command.
Format
clock timezone
zone-name +/-hours-offset [+/-minutes-off-
set]
[no] clock timezone
Parameters
Zone name
A name to associate with the time zone
Hours-offset
Number of hours difference with UTC
Minutes-offset
Number of minutes difference with UTC
Mode
Global Config
Default
[no] clock timezone
4.4 MAC Address and MAC Database Commands
This section describes the commands you use to configure and view information about the
system MAC address and the MAC address table.
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
