Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
5-2
Spanning Tree Protocol Commands
v1.0, February 2007
5.1.1.1 no spanning-tree
This command sets the spanning-tree operational mode to disabled. While disabled, the
spanning-tree configuration is retained and can be changed, but is not activated.
Format
no spanning-tree
Mode
Global Config
5.1.2 spanning-tree bpdumigrationcheck
This command enables BPDU migration check on a given interface. The
all
option
enables BPDU migration check on all interfaces.
Format
spanning-tree bpdumigrationcheck {<slot/port> |
all}
Mode
Global Config
5.1.2.1 no spanning-tree bpdumigrationcheck
This command disables BPDU migration check on a given interface. The
all
option
disables BPDU migration check on all interfaces.
Format
no spanning-tree bpdumigrationcheck {<slot/port> |
all}
Mode
Global Config
5.1.3 spanning-tree configuration name
This command sets the Configuration Identifier Name for use in identifying the
configuration that this switch is currently using. The
<name>
is a string of up to 32
characters.
Default
base MAC address in hexadecimal notation
Format
spanning-tree configuration name
<name>
Mode
Global Config
5.1.3.1 no spanning-tree configuration name
This command resets the Configuration Identifier Name to its default.
Format
no spanning-tree configuration name
Mode
Global Config
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
