ProSafe Quad WAN Gigabit Firewall FR538G Reference Manual
5-10
Router and Network Management
v1.0, November 2007
To configure your firewall for Remote Management:
1.
Select
Administration
from the main menu and
Remote Management
from the submenu.
The
Remote Management
screen will display.
2.
Check
Allow Remote Management
radio box.
3.
Specify what external addresses will be allowed to access the firewall’s remote management.
a.
To allow access from any IP address on the Internet, select Everyone.
b.
To allow access from a range of IP addresses on the Internet, select IP address range.
Enter a beginning and ending IP address to define the allowed range.
c.
To allow access from a single IP address on the Internet, select Only this PC.
Enter the IP address that will be allowed access.
4.
Specify the Port Number that will be used for accessing the management interface.
Web browser access normally uses the standard HTTP service port 80. For greater security,
you can change the remote management Web interface to a custom port by entering that
number in the box provided. Choose a number between 1024 and 65535, but do not use the
number of any common service port. The default is 8080, which is a common alternate for
HTTP.
Figure 5-2
Note:
For enhanced security, restrict access to as few external IP addresses as
practical.
Summary of Contents for ProSafe Quad WAN FR538G
