ProSafe Quad WAN Gigabit Firewall FR538G Reference Manual
Connecting the FR538G
2-15
v1.0, November 2007
2.
Enter the following data in the
Add Protocol Binding
section:
a. Service
– From the pull-down menu, select the desired Services or applications to be
covered by this rule. If the desired service or application does not appear in the list, you
must define it using the Services menu (see
“Services-Based Rules” on page 4-2
).
b. Destination Network
– These settings determine which Internet locations are covered by
the rule, based on their IP address. Select the desired option:
•
Any
– All Internet IP address are covered by this rule.
•
Single address
– Enter the required address in the start fields.
•
Address range
– If this option is selected, you must enter the start and finish fields.
c.
Source Network
– These settings determine which computers on your network are
affected by this rule. Select the desired options:
•
Any
– All PCs and devices on your LAN.
•
Single address
– Enter the required address and the rule will be applied to that
particular PC.
Figure 2-6
Summary of Contents for ProSafe Quad WAN FR538G
