ProSafe Quad WAN Gigabit Firewall FR538G Reference Manual
Troubleshooting
6-7
v1.0, November 2007
Restoring the Default Configuration and Password
This section explains how to restore the factory default configuration settings, changing the
firewall’s administration password to
password
and the IP address to 192.168.1.1. You can erase
the current configuration and restore factory defaults in two ways:
•
Use the Erase function of the firewall (see
“Backup and Restore Settings” on page 5-14
•
Use the reset button on the front panel of the firewall. Use this method for cases when the
administration password or IP address is not known.
To restore the factory default configuration settings without knowing the administration password
or IP address, you must use the reset button on the front panel of the firewall.
To restore the factory defaults:
1.
Press and hold the reset button until the Test LED turns on and begins to blink (about 10
seconds).
2.
Release the reset button and wait for the firewall to reboot.
Problems with Date and Time
The E-Mail menu in the Content Filtering section displays the current date and time of day. The
quad WAN gigabit firewall uses the Network Time Protocol (NTP) to obtain the current time from
one of several Network Time Servers on the Internet. Each entry in the log is stamped with the date
and time of day. Problems with the date and time function can include:
•
Date shown is January 1, 2000. Cause: The firewall has not yet successfully reached a
Network Time Server. Check that your Internet access settings are configured correctly. If you
have just completed configuring the firewall, wait at least five minutes and check the date and
time again.
•
Time is off by one hour. Cause: The firewall does not automatically sense Daylight Savings
Time. Check the Time Zone menu, and check or uncheck the box marked “Adjust for Daylight
Savings Time”.
Summary of Contents for ProSafe Quad WAN FR538G
