ProSafe Quad WAN Gigabit Firewall FR538G Reference Manual
4-10
Firewall Protection and Content Filtering
v1.0, November 2007
allowing inbound services opens holes in your firewall. Only enable those ports that are necessary
for your network.
To create a new inbound service rule:
1.
Click
Add
under the Inbound Services Table. The
Add LAN WAN Inbound Service
screen
will display.
2.
Complete the Add WAN LAN Inbound Services screen (see
3.
Click
Reset
to cancel your settings and return to the previous settings.
4.
Click
Apply
to save your changes and reset the fields on this screen. The new rule will be
listed on the
Inbound Services
table.
Setting DMZ WAN Rules
The firewall rules for traffic between the DMZ and the WAN/Internet are configured on the
DMZ
WAN Rules
screen. The Default Outbound Policy is to allow all traffic from and to the Internet to
pass through. Firewall rules can then be applied to block specific types of traffic from either going
out from the DMZ to the Internet (Outbound) or coming in from the Internet to the DMZ
Figure 4-4
Summary of Contents for ProSafe Quad WAN FR538G
