NetGear Print Server Manual
List of FTP Files and Commands Supported by the Print Server
Table FTP Files in the Directory lists the file names that appear in the directory.
FTP Files in the Directory
File Name
Purpose
Mode
CONFIG Configuration
file
Read/Write
PSINF Device
information
Read
DEFAULTC
Reset device to default configuration Read
RESET Reset
device
Read
PASSRESET Clear password
Read
SETIP
Save current IP address
Read
Table FTP Commands lists the case-sensitive commands that are implemented. When a command
requires a parameter, the parameter is shown in italics.
FTP Commands
Command Function
dir
Lists files as shown in table FTP Files in the Directory.
get FILENAME Retrieves a file. The only files that can be retrieved are CONFIG and PSINF.
get RESET
Resets the print server and terminates the current connection.
get
PASSRESET
Clears the password.
get SETIP
Sets the current IP address as a static IP address.
To avoid an address conflict, do not use this command if a DHCP server assigned the IP address to the print
server.
put CONFIG
Copies the CONFIG file to the print server, overwriting the existing CONFIG file. After using this command to
write a new configuration file, use the get RESET command; all LEDs should turn on and then off while the
print server is resetting.
put
PASSWORD
Copies the password file to the print server and gives it a new password. Passwords can be up to 19 bytes in
length.
put filename Ln Copies the filename file to the printer connected to n port and prints the file.
quit
Terminates the current FTP session.
Other FTP commands cannot be used, and they return an Invalid Command error message.
56
