NETGEAR USB Multifunction Printer Server PS121v2 User Manual
2-8
Setup
v1.1, September 2006
Set Up Each Additional PC to Use the PS121v2
After you have set up the PS121v2 in your network and connected it to one computer, you need to
set up each additional computer to use the PS121v2. You do this by using the
Resource CD
to run
the setup according to the steps below.
1.
Power on your computer, let the operating system boot up completely, and log in as needed.
2.
Insert the
Resource CD
for the PS121v2 into your CD-ROM drive. The CD main page will
load.
3.
Click
Set Up the PC to Use an Installed Print Server
to install the SmartWizard, which will
allow you to print via the print server.
Your USB Multifunction Print Server is now ready to use. For instructions on using the
multifunction feature, refer to
“Reserving a Printer for Exclusive Use by One PC” on page 3-1
.
Warning:
For Windows 98SE and Windows ME, print manager software from Epson
and from some HP printers can block communications between your PC and
the PS121v2. Uninstall such print manager software before proceeding with
the Add Printer Port Wizard.
Figure 2-5
