ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
Performing Network and System Management
3-11
v1.0, September 2009
3.
Under the Administrator Settings and Guest Settings sections of the screen, click
Apply
to
save your settings.
4.
If you modified the administrator settings and now want to modify the guest settings, or the
other way around, repeat
step 2
and
step 3
for the other settings.
5.
To modify the Web Management Interface timeout settings, complete the field as explained in
Table 3-5
.
6.
Under the Web Interface Timeout section of the screen, click
Apply
to save your settings.
Configuring Remote Management Access
An administrator can configure, upgrade, and check the status of the STM over the Internet via a
Secure Sockets Layer (SSL) VPN connection.
You must use an SSL VPN connection to access the STM from the Internet. You must enter
https://
(not
http://
) and type the STM’s WAN IP address into your browser. .For example, if the
STM’s WAN IP address is 172.16.0.123, type the following in your browser:
https://172.16.0.123
.
The STM’s remote login URL is:
New Password
Enter the new password.
Retype New Password Confirm the new password.
Table 3-5. Set Password Settings screen: Web Interface Timeout Settings
Setting
Description (or Subfield and Description)
Web Interface Timeout
Session Timeout
Enter the period in seconds after which the Web Management Interface is
automatically logged off if no activity is detected. The default is 600 seconds.
The maximum period that you can configure is 9999 seconds. To disable
session timeout entirely so that the Web Management Interface is never
logged off because of inactivity, enter 0.
Note:
After a factory default reset, the password and timeout value are changed back to
password
and 600 seconds (5 minutes), respectively.
Table 3-4. Set Password Settings screen; Administrator and Guest Settings (continued)
Setting
Description (or Subfield and Description)
DRAFT