ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
7-10
Virtual Private Networking Using IPsec Connections
v1.0, September 2009
3.
Select the radio buttons and complete the fields and as explained
Table 7-3
.
.
Table 7-3. (IPsec) VPN Wizard Settings for a Client-to-Gateway Tunnel
Setting
Description (or Subfield and Description)
About VPN Wizard
This VPN tunnel will connect
to the following peers
Select the
VPN Client
radio button. The default remote FQDN
(utm_remote.com) and the default local FQDN (utm_local.com) appear
in the End Point Information section of the screen.
Connection Name and Remote IP Type
What is the new Connection
Name?
Enter a descriptive name for the connection. This name is used to help
you to manage the VPN settings; the name is not supplied to the
remote VPN endpoint.
What is the pre-shared key?
Enter a pre-shared key. The key must be entered both here and on the
remote VPN gateway, or the remote VPN client. This key must have a
minimum length of 8 characters and should not exceed 49 characters.
This VPN tunnel will use
following local WAN Interface
(UTM25 only)
For the UTM25 only, select one of the two radio buttons (
WAN1
or
WAN2
) to specify which local WAN interface the VPN tunnel uses as
the local endpoint.
Note
: If the UTM25 is configured to function in WAN auto-rollover
mode, after completing the wizard, you must manually update the VPN
policy to enable VPN rollover. For more information, see
“Manually
Adding or Editing a VPN Policy” on page 7-32
.
End Point Information
a
a. Both local and remote endpoints should be defined as either FQDNs or IP addresses. A combination of an IP address and
a FQDN is not supported.
What is the Remote Identifier
Information?
When you select the Client radio button in the About VPN Wizard
section of the screen, the default remote FQDN (utm_remote.com) is
automatically entered. Use the default remote FQDN or enter another
FQDN.
What is the Local Identifier
Information?
When you select the Client radio button in the About VPN Wizard
section of the screen, the default local FQDN (utm_local.com) is
automatically entered. Use the default local FQDN or enter another
FQDN.
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?
These fields are masked out for VPN client connections.
What is the remote LAN
Subnet Mask?
