ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
Virtual Private Networking Using IPsec Connections
7-51
v1.0, September 2009
4.
Click on the disk icon to save the configuration, or select
File
>
Save
from the Security Policy
Editor menu.
Use
Select the
Use
checkbox. Then, from the pull-down menu, select
Secure
Gateway Tunnel
.
ID Type
Left pull-down menu
From the left pull-down menu, select
Domain Name
.
Then, below, enter the local FQDN that you specified
in the UTM’s Mode Config IKE policy. In this example,
we are using utm25_local.com.
Right pull-down menu
From the right pull-down menu, select
Gateway IP
Address
. Then, below, enter the IP address of the
WAN interface that you selected on the UTM’s VPN
Wizard screen (see
Figure 7-9 on page 7-9
). In this
example, the WAN IP address is 192.168.50.61.
Note
: You can find the WAN IP address on the
Connection Status screen for the selected WAN port.
For more information, see
“Viewing the WAN Ports
Status” on page 11-27
.
Table 7-17. Security Policy Editor: Remote Party, Mode Config Settings (continued)
Setting
Description (or Subfield and Description)
