3. Configure the AP Router via Web Management Page
This device works in AP mode by default, so if you are intend to change the working mode or
any settings, please connect your computer to or
Port of AP and set a static IP for
you computer as below steps:
3.1 Set a Static IP for PC
Manually set the IP address of the wired network adapter on your computer as below.
IP Address/ IPv4 Address
: 192.168.1.x (1<x<255)
Subnet Mask
: 255.255.255.0
Default Gateway/ Router
: 192.168.1.1
For Windows 8/ 7/Vista
1) Go to “
Settings
” (for Windows 8)/“
Start
” (for Windows 7/Vista) > “
Control Panel
”.
2) Left-click on “
Network and Internet
” > “
Network and Sharing Center
” > “
Change
adapter settings
” (for Windows 8/ 7)/”
Manage network connections
” (for Windows Vista).
3) Right-click on “
Local Area Connection
” and left-click on “
Properties
”.
4) Double-click on “
Internet Protocol Version 4 (TCP/IPv4)
”.
5) Select “
Use the following IP address
” then left-click on “
OK
”.
For Windows XP/2000
1) Go to “
Start
” > “
Control Panel
”.
2) Left-click on “
Network and Internet Connections
” > “
Network Connections
”.
3) Right-click on “
Local Area Connection
” and left-click on “
Properties
”.
4) Double-click on “
Internet Protocol (TCP/IP)
”.
5) Select “
Use the following IP address
” then left-click on “
OK
”.
For MAC OS
1) Click on the “
Apple
” menu > “
System Preferences
”.
2) Click on the “
Network
” icon.
3) Click on “Ethernet” in the left side box and click on “
Advanced
” in the lower right corner.
4) In the top options, select “
TCP/IP
”.
5) In the pull-down menu next to “
Configure IPv4
” select “
Manually
”.
6) Fill in the “
IPv4 Address/Subnet Mask/Router
” parameters, and click “
OK
” then “
Apply
”.
4
netis Wireless High Power Outdoor AP Router Quick Installation Guide
2. The connection will be similar to the figure below after the above steps are finished.
connect to xDSL or
Cable modem/router
Ethernet
Cable
Main Electrical Supply
INDOOR
Power Cable
PoE Injector
POWER
Internet
LAN/WAN
AP/AP Router
