- ENGLISH -
- 77 -
Email config menu
The
config
menu shows a screen like the one below.
/------------------------/
/ Email config /
/------------------------/
Email address 1:
myself@mycompany.com
Email address 2:
service@service.com
Email address 3:
anotheremail@mycompany.com
Sender address.:
NetMan_plus
Customer.......:
MyCustomer
Report interval:
01-05:10
DD-HH:MM
User name......:
User 1
Password.......:
Password
This menu may be used to configure the addresses to which to send the alarm notification and
report e-mails and other parameters of the e-mail service as described in the following table.
Field
Parameters to be inserted
Email address 1
Enter the e-mail addresses to which to send the alarm notifications
and reports (see note).
Email address 2
Email address 3
Sender address
Enter the address from which the e-mails are sent.
(1)
Customer
Enter an identifying string; this additional information is included in
the e-mail.
Report interval
Enter the delay, measured in days, between the sending of one
report e-mail and the next by using exactly 2 figures, followed by a
line, an finally by the hour and minutes on which the email should be
sent.
User name
If the server requires authentication, enter the required user name
Password
If the server requires authentication, enter the required password
(1)
do
not use the “space” character in this field
After inserting the data and pressing the “ESC” key to exit from the menu, the service can be
tested by pressing the “T” key. If the test is performed, a “@” is displayed and a test email is sent
to all the configured email addresses. After this the previous menu is shown.
NOTE:
Report e-mails are sent to all the addresses inserted; for alarm notification e-mails see
paragraph “
Email logic
menu”.
