174
If you check the
Idle Reset
checkbox, a match on this rule will keep the WAN connection
alive by resetting the idle-timeout status.
The Idle Reset setting is used to determine if a packet which matches the filter will cause
an “instant-on” link to connect, if it is down; or reset its idle timer, if it is already up. For
example, if you wanted ping traffic not to keep the link up, you would create a filter which
for wards a ping, but with the Idle Reset checkbox unchecked.
Example:
You want packets with the TOS low
latency bit to go through VC 2 (via gateway
127.0.0.3 – the Netopia Gateway will use
127.0.0.
x
, where
x
is the WAN por t + 1) instead
of your normal gateway.
You would set up the filter as shown here.
☛
NOTE:
Default Forwarding Filter
If you create one or more filters that have a matching action of
for ward
, then
action on a packet matching
none
of the filters is to block any traffic.
Therefore, if the behavior you want is to force the routing of a cer tain type of
packet and pass all others through the normal routing mechanism, you must
Summary of Contents for 3342
