271
CONFIG Commands
set security ipsec tunnels name "123" tun-enable
(on) {on | off}
This enables this par ticular tunnel. Currently, one tunnel is suppor ted.
set security ipsec tunnels name "123" dest-ext-address
ip-address
Specifies the IP address of the destination gateway.
set security ipsec tunnels name "123" dest-int-network
ip-address
Specifies the IP address of the destination computer or internal network.
set security ipsec tunnels name "123" dest-int-netmask
netmask
Specifies the subnet mask of the destination computer or internal network. The subnet
mask specifies which bits of the 32-bit IP address represents network information. The
default subnet mask for most networks is 255.255.255.0 (class C subnet mask).
set security ipsec tunnels name "123" encrypt-protocol
(ESP) { ESP | none }
See
page 130
for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" auth-protocol
(ESP) {AH | ESP | none}
See
page 130
for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" IKE-mode
pre-shared-key-type (hex) {ascii | hex}
See
page 130
for details about SafeHarbour IPsec tunnel capability.
Summary of Contents for 3342
